The JTD18G-H5CH (JTD-322) allows users to extract digital HDMI audio signals from an HDMI compliant source to L/R analog out 2CH or digital audio 2CH / 5CH output. The unit supports 4k video resolution at 60Hz, HDR10, and is HDCP 2.2 compliant (Users must use an HDMI 2.0 certified cable to achieve these features)
*Note: Simultaneous audio from L/R Out, Optical Out and HDMI can only be achieved if the source audio signal is set to PCM / Stereo
**Note: This unit does not support ARC function, and will not extract audio if using TV as a source
Setup:
Connect the source device (Blu-ray, cable box etc.) in to the HDMI input of the extractor. The “Link” LED will illuminate indicating that an HDMI input signal has been detected
Connect the display to the HDMI output of the extractor
Connect the 5V power adapter to the extractor. The “Power” LED will illuminate indicating that the extractor is receiving power
Connect the audio device to the “L/R” output or “Optical” output port of the audio extractor
If using the “L/ROut” port, please verify that the EDID switch on the unit is set to “2CH“. Also verify that the audio format from the source is PCM / Stereo
If using the “Optical Out” port, the EDID switch can be set to either “2CH” or “5CH” depending on audio device’s supported audio formats
Troubleshooting Steps:
No Video:
Check to see if the “Link” light on the extractor is illuminated. If not, make sure that the HDMI cables are tested to be functional
Ensure that the source device is outputting a compatible resolution and refresh rate
The source and the display would need to be HDCP compliant
No Audio:
Ensure that the source device is outputting either Stereo or standard Dolby 5.1 audio format, not Dolby Digital Plus
If the incoming signal is Stereo, all outputs (RCA, SPDIF, and HDMI) will pass sound through
If the incoming signal is Dolby 5.1, only Optical and HDMI output ports will pass sound through
Since this unit does not support ARC, a source device has to be plugged in to the HDMI In port. If a TV is being used as a source via ARC, the unit will not function and pass any audio
J-Tech Digital Support Team1-888-610-2818support@jtechdigital.com
Since the launch of the new generation consoles, Xbox Series X/S, and the PlayStation5, some users are unable to utilize their legacy audio equipment due to the lack of an Optical port on the...
The JTECH-AET1000 Digital Audio Extender allows customers to extend their optical or coaxial audio signal up to 900ft. over Ethernet (Cat5e/6). The extender supports audio formats such as Dolby Digital, DTS 5.1, DTS-HD, and...
JTECH-WEX-22D / JTD-351 Wireless HDMI Extender
Operating Frequencies
The J-Tech Digital JTECH-WEX-22D wireless HDMI extender set makes HDMI signal extension simple by wirelessly transmitting a source HDMI signal to an HDMI display. To avoid interference with...
The JTECH-WEX300 (JTD-426) allows users to wirelessly extend their HDMI signal up to 500ft*. The unit supports 1 Transmitter to 1 Receiver, and automatically scans and operates on unoccupied channels within the 5GHz wireless band....
The JTECH-WEX-22 (JTD-1263) allows users to wirelessly extend their HDMI signal up to 164ft / 50m. The unit utilizes the 5GHz wireless band with manual channel selection capability to avoid interference. Supports 1080P video...
The JTECH-EXBT460 (JTD-460) HDMI Extender can extend a 4K video signal up to 131 feet / 40M, and a 1080P video signal up to 230 feet / 70M over a single CAT5e/6/7 cable. The...
The JTD4KAT0301SW allows for up to 3 source devices to be connected to a single display, while extracting the audio to a sound system via SPDIF/Optical or L/R Analog
Setup (Using ARC functionality):
Please note...
The JTECH-VW02 supports a 2x2 video wall configuration, and with the purchase of additional units, the multi-level cascading function allows for up to a 10x10 video wall
Default Settings For the Display Arrangement Is...
Changing the default IP of the JTECH-8X8-H20 HDMI Matrix
Connect the power cable to the 8x8 Matrix
Connect an Ethernet cable (Cat5e/Cat6) to the TCP/IP port of the Matrix and to the port on your...
J-Tech Digital Premium Quality 1080P HDMI To HDMI + Audio (SPDIF + RCA Stereo) Audio Extractor Converter
Before setting up, make sure you have the following:
Provided 5VDC Power Adapter
(2) HDMI Cables (ver. 1.4...